• Ensure that the surface is clean and free from dampness, dirt and other contamination

• For areas severly affected by algae and fungi, ensure that the surface is completely cleaned with Bio-wash before intiating the painting process

• Sand the surface using #180 Sandpaper and clean thoroughly. Ensure that no loose particles are sticking to the wall.

• Freshly plastered surfaces must be allowed to cure completely. The coating process can be started after a minimum period of 30 days.

AVAILABLE IN MATT AND SHEEN FINISHES
APPLICATION PROCEDURE
EXTERIOR WALLS

APPLICATION PROCEDURE
EXTERIOR WALLS
• Apply 1-2 coats of Altura Wall Primer with an interval of 4-5 hours between subsequent coats.
• Sanding of first/second coat of Altura Wall Primer can be done with sandpaper #320.
• Apply 2 coats of Abura Emulsion with an interval of 4-5 hours between subsequent coats.
• Sanding of the topcoat can be done with sandpaper #600.
INTERIOR WALLS
• Ensure that fresh walls are coated with one or two coats of white cement.
• Apply 2 coats of Abura Wall Primer with an interval of 4-5 hours between subsequent coats.
• Undulations in the wall can be leveled MRF VILASA Wall putty. • Putty should be used between the first and second coat of Altura Wall Primer and sanding of the putty shall be done as per
recommendation.
• Apply 2 coats Abura Emulsion with an interval of 4-5 hours between subsequent coats, after subjecting the second coat of Altura Wall Primer to sanding using sandpaper #320.
• Sanding of the topcoat can be done with sandpaper #600. •The number of coats of topcoats depends on the chosen colour. Darker shades may require additional coats.

Conventional Spray, Nozzle Orifice: 0.059 inches,
Pressure: 35-45 psi.

Thinner Recommended – Thinner for Finish (TFF)